MakerBot Replicator Error Code 1008

QuestionsCategory: MakerbotMakerBot Replicator Error Code 1008
best3d Staff asked 8 months ago

What is the solution for MakerBot Replicator Error Codes 1008

1 Answers
best3d Staff answered 8 months ago

If you are seeing error 1008 there may be an issue with your extruder cable. The extruder cable connects the extruder carriage to the 3D printer and transmits power and printing instructions to the Smart Extruder+/Smart Extruder.



If you see one of these error messages, turn off your MakerBot Replicator. If you are in the middle of a print, wait for the extruder to cool before turning off your MakerBot Replicator. If you have MakerBot Desktop open, dismiss the error message dialog. The extruder cable is a flat white flex cable that runs from the extruder carriage to the rear right corner of the printer. Check the cable where it connects to the extruder carriage. if the connection to the carriage look failed If the connection is loose, use a small tool, such as a hex wrench to carefully push the connector into the port on the extruder carriage and make sure it is firmly in place.     It sounds like there’s a problem with the cable. Please open a case with MakerBot Support. Make sure to include your shipping information and your printer’s serial number.  

Save up to 70%

3d Printer Coupons & Deals

Choose A Format
Open List
Open List

Add A Knowledge Base Question !

You will get a notification email when Knowledgebase answerd/updated!

+ = Verify Human or Spambot ?