Sindoh 3DWOX DP200 Error Code 501

QuestionsCategory: SindohSindoh 3DWOX DP200 Error Code 501
best3d Staff asked 6 months ago

What is the solution for Sindoh 3DWOX DP200 Error Code 501

1 Answers
best3d Staff answered 6 months ago

1.Check the condition of a X-axis Sensor


(Location of a Sensor)
It is located where a dotted circle is above.

(Check the location of a Sensor)
A sensor is located inside the printer as shown in the picture above.

Check that the Sensor stays in position and whether it is properly assembled to the connector
(Left Picture) Normal – The sensor does not move when pushed inward.
(Right Picture) Abnormal – The sensor goes out of position when pushed inward.

2. If the Sensor is Out of Position


(Detach the Sensor)
Detach the Sensor completely

(Re-assemble the Sensor)
1.Re-assemble the Harness to the Connector
2.Tilt the Sensor and insert the lower part to the hole first.

(Sensor Re-assemble)
Finish re-assembling by inserting the upper part.

Choose A Format
Open List
Open List

Add A Knowledge Base Question !

You will get a notification email when Knowledgebase answerd/updated!

+ = Verify Human or Spambot ?