Part of a 3D printed objects that hangs over the worktable. When the overhangs are too big (usually over 60 degrees in relation to worksurface) it is more difficult to fabricate. These parts should be printed with a support, so the filament doesn’t spill to the surface.

Last Update: April 21, 2017  

April 21, 2017   662   best3d    3D Printing Dictionary  
Total 0 Votes:

Tell us how can we improve this post?

+ = Verify Human or Spambot ?

Add A Knowledge Base Question !

You will get a notification email when Knowledgebase answerd/updated!

+ = Verify Human or Spambot ?

Leave a Reply

Your email address will not be published. Required fields are marked *